#ifndef _ZVGCMDS_H_
#define _ZVGCMDS_H_
/*****************************************************************************
* Define ZVG command set data.
*
* Author:  Zonn Moore
* Created: 11/06/02
*
* History:
*
* (c) Copyright 2002, Zektor, LLC.  All Rights Reserved.
*****************************************************************************/

// Bitmaps that make up the ZVG vector commands

#define		zbHZVT		0x04	// Bit set if a horizontal or vertical line being drawn
#define		zbVERT		0x02	// Bit set if above HZVT line is Vertical

#define		zbYLEN		0x04	// Bit set if Y is given as length
#define		zbRATIO		0x08	// Bit set if RATIO value given
#define		zbVECTOR		0x10	// Bit set if VECTOR command (as opposed to POINT)
#define		zbSHORT		0x20	// Bit set if 8 bit SHORT offsets given
#define		zbCOLOR		0x40	// Bit set if color information given
#define		zbABS			0x80	// Bit set if starting X/Y given.

// List of extended commands

#define		zcEXTENDED	0xE0	// extended commands

#define		zcNOP			0xE0	// Do nothing
#define		zcBLINK		0xE1	// Blink VTG LED
#define		zcZSHIFT		0xE2	// Set Z-Shift
#define		zcOSHOOT		0xE3	// Set Overshoot
#define		zcJUMP		0xE4	// Set JUMP factor
#define		zcSETTLE		0xE5	// Set min Settling time
#define		zcPOINT_I	0xE6	// Set POINT Intensity
#define		zcMIN_I		0xE7	// Set MIN DAC Intensity
#define		zcMAX_I		0xE8	// Set MAX DAC Intensity
#define		zcSCALE		0xE9	// Set Scale size
#define		zcSAVE_EE	0xEA	// Save current setting into EEPROM
#define		zcLOAD_EE	0xEB	// Restore current setting from EEPROM
#define		zcREAD_MON	0xEC	// Send current monitor settings to Host
#define		zcRESET_MON	0xED	// Reset monitor to factory default settings
#define		zcREAD_SPD	0xEE	// Read speed table values

#define		zcCENTER		0xEF	// Center beam

#endif